LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2023 >> LX 600 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Can Communication System - Circuit Tests (1 Of 4) & Diagnostic Codes >> Can Communication System >> DTC U0122: CAN Communication Error (VSC); DTC U0129-87: Lost Communication With Brake System Control Module Missing Message; DTC U1159-87: Lost Communication with Electronic Brake Booster Control Module "A" (ch3) Missing Message; DTC U115C-00: Lost Communication with ECM/PCM "A" (ch5); DTC U115C-87: Lost Communication with ECM/PCM "A" (ch5) Missing Message; DTC U1170-87: Lost Communication With Brake System Control Module (ch2) Missing Message; DTC U117D-87: Lost Communication with Brake System Control Module (ch4) Missing Message [12/2021 - ] >> Caution / Notice / Hint
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Caution / Notice / Hint

WARNING:

When performing the confirmation driving pattern, obey all speed limits and traffic laws.

NOTE:
  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2021 - ]

  • Before measuring the resistance of the CAN bus, turn the ignition switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
  • After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [12/2021 - ]

  • When disconnecting and reconnecting the battery.

    HINT: 

    When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [12/2021 - ]

  • Some parts must be initialized and set when replacing or removing and installing parts.

    Refer to WORK PROCEDURE [12/2021 - ]

  • After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.

    DTC check procedure: Turn the ignition switch to ON and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.

  • After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.

    Refer to DIAGNOSIS SYSTEM [12/2021 - ]

HINT: 

scientia non olet · About LEMON Manuals