DTC P1235-13: High Pressure Fuel Pump Circuit Open [12/2021 - ]: Procedure

Refer to INSPECTION [12/2021 - ]

HINT: 

Perform "Inspection After Repair" after replacing the fuel pump assembly (for high pressure side).

Refer to INITIALIZATION [12/2021 - ]

Result

Result: 

NG 

REPLACE FUEL PUMP ASSEMBLY (FOR HIGH PRESSURE SIDE). Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  2

Pre-procedure1

• Disconnect the ECM connector.
• Disconnect the fuel pump assembly (for high pressure side) connector.

• Measure the resistance according to the value(s) in the table below.

  Standard Resistance

  Tester Connection	Condition	Specified Condition
  C43-2 (FP+) - C37-11 (FP1+)	Always	Below 1 Ω
  C43-1 (FP-) - C37-10 (FP1-)	Always	Below 1 Ω
  C43-2 (FP+) or C37-11 (FP1+) - Body ground and other terminals	Always	10 kΩ or higher
  C43-1 (FP-) or C37-10 (FP1-) - Body ground and other terminals	Always	10 kΩ or higher

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR