Confirmation Driving Pattern

HINT: 

• This DTC indicates that a malfunction of the integrated capacitor is detected and a malfunction signal is being sent to the ECM.

  The malfunction signal is not cleared by the GTS but will be cleared when the internal voltage of the integrated capacitor is completely discharged after the ignition switch is turned off.

  Therefore, when rechecking for DTCs after replacing components, clearing the DTCs, etc., as it is necessary to clear the malfunction judgement signal from the integrated capacitor, check for or clear DTCs after waiting 10 minutes or more after turning the ignition switch off.

• After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the All Readiness check procedure.

  Refer to UTILITY [11/2021 - ]

1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
2. Turn the ignition switch to ON and wait for 10 seconds or more.
3. Turn the ignition switch off and wait for 10 minutes or more.
4. Turn the ignition switch to ON.
5. Enter the following menus: Powertrain / Transmission / Utility / All Readiness.
6. Check the DTC judgment result.

   HINT: 

   • If the judgment result shows NORMAL, the system is normal.
   • If the judgment result shows ABNORMAL, the system has a malfunction.
   • If the judgment result shows INCOMPLETE, perform driving pattern again.