DTC P2E00-64: Gear Lever Position Sensor "A" Signal Plausibility Failure; DTC P2E04-64: Gear Lever Position Sensor "B" Signal Plausibility Failure; DTC P2E08-64: Gear Lever Position Sensor "C" Signal Plausibility Failure [11/2021 - ]: Procedure

Pre-procedure1

1. Turn the ignition switch to ON.

   Procedure1

2. Using the GTS, perform a Health Check.
3. Check for DTCs.

   Result

   Proceed to
   NEXT

   Post-procedure1

4. Turn the ignition switch off.

Result: 

NEXT 

See step  2

Pre-procedure1

1. Turn the ignition switch to ON.

   Procedure1

2. Clear the DTCs.

   Powertrain > Transmission > Clear DTCs 

   Result

   Proceed to
   NEXT

   Post-procedure1

3. Turn the ignition switch off.
4. Disconnect the GTS.
5. Leave the vehicle as is for 60 seconds or more.
   NOTE:

   • Do not connect the GTS.
   • Do not depress the brake pedal.
   • Do not open/close any of the doors.

Result: 

NEXT 

See step  3

Pre-procedure1

1. Start the engine and wait for 1 minute or more.
2. Turn all switches off and turn the ignition switch off.
3. Disconnect the GTS.
4. Wait for 5 minutes or more with the door lock locked.

   HINT: 

   • Once the door lock is locked, keep the electrical key transmitter sub-assembly (electrical key) 3 m (9.84 ft.) or more away from the vehicle.
   • Because the system will not sleep while any door and/or the hood is open, take steps such as securing the courtesy switch to make the system recognize the doors and hood as closed when carrying out the operation.
   • If the vehicle is equipped with a power back door, the system will not sleep if the back door is not closed. Ensure that the back door is closed before carrying out the operation.
5. Start the engine and wait for 1 minute or more.

   Procedure1

6. Check for DTCs.

   Powertrain > Transmission > Trouble Codes 

   Result

   Result	Proceed to
   Only P2E00-64, P2E04-64 or P2E08-64 is output	A
   P2E00-64, P2E04-64 or P2E08-64 and other DTCs are output	B
   DTCs are not output	C

   Post-procedure1

7. Turn the ignition switch off.

Result: 

A 

REPLACE TRANSMISSION FLOOR SHIFT ASSEMBLY (SHIFT CONTROL ECU). Refer to  REMOVAL [11/2021 - ] 

Result: 

B 

GO TO DTC CHART. Refer To  DIAGNOSTIC TROUBLE CODE CHART [11/2021 - ] 

Result: 

C 

CHECK FOR INTERMITTENT PROBLEMS 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]

Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE [11/2021 - ]