DTC U0100: Lost Communication with ECM / PCM "A"; DTC U0101: Lost Communication with TCM; DTC U0122: Lost Communication With Vehicle Dynamics Control Module; DTC U0124: Lost Communication with Lateral Acceleration Sensor Module; DTC U0126: Lost Communication with Steering Angle Sensor Module; DTC U1103: Lost Communication with Stop and Start Control Module; DTC U114C: Lost Communication with Suspension Control Module 1 [12/2021 - ]: Procedure

Pre-procedure1

1. Turn the ignition switch to ON.

   Procedure1

2. Clear the DTCs.

   Chassis > Adaptive Variable Suspension System > Clear DTCs 

   Result

   Proceed to
   NEXT

   Post-procedure1

3. Turn the ignition switch off.

Result: 

NEXT 

See step  2

Pre-procedure1

1. Drive the vehicle at a speed of 30 km/h (19 mph) or more for 10 seconds or more.

   Procedure1

2. Check for DTCs.

   Chassis > Adaptive Variable Suspension System > Trouble Codes 

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

   HINT: 

   If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor.

   Post-procedure1

3. None

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2021 - ] 

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2021 - ]