Window Regulator: Installation
- With glass in the full-up position, install window regulator through the access hole in the door. Insert the slide into the glass bracket C-channel.
- Slide the glass run tube assembly down into position in the door. Loosely install the upper screw and washer and lower nut and washer.
- Position the regulator base plate to the inner door panel and install four rivets.
- Adjust door glass. See DOOR GLASS under ADJUSTMENTS.
- Connect the electric motor wiring.
- Cycle the door glass to ensure proper operation.
- Install the door trim panel and watershield.
NOTE:
1/4-20x1 inch screws and 1/4-20 nuts and washers may be substituted for the rivets. Tighten to 84-120 INCH lbs. (9-14 N.m).