October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Driver's Door Module Communication Error
- Check Power Supply
- Disconnect 14-pin harness connector from Driver's Door Module (DDM). Measure voltage between ground and Light Green/Purple wire at 14-pin connector. If battery voltage exists, go to step 4). If battery voltage is not present, go to next step.
- Check Light Green/Purple Wire For Short
- Remove fuse No. 39 at interior fuse panel. Measure resistance between Light Green/Purple wire and ground. If resistance is greater than 10 k/ohms, go to next step. If resistance is less than 10 k/ohms, repair Light Green/Purple wire for short to ground.
- Check Power At Fuse No. 39
- Check for battery voltage at fuse No. 39 cavity. If battery voltage exists, repair Light Green/Purple wire for open. If battery voltage is not present, repair open power supply to fuse panel. See POWER DISTRIBUTION.
- Check Ground Circuits
- Disconnect DDM 14-pin connector. Measure resistance between ground and Black wire and Black/Light Blue wire at 14-pin connector. If resistance is greater than 5 ohms, repair open Black or Black/Light Blue wire. If resistance is less than 5 ohms, see MODULE COMMUNICATIONS NETWORK
article for network diagnostics.