Specifications Index
CONTINENTAL SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut Rear | 188-254 Ft. Lbs. (255-344 N.m) | |
| Brakes | ||
| Bleeding Sequence | BRAKELINE BLEEDING SEQUENCE | |
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | BELT ROUTING | |
| Engine Cooling | ||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 13-18 Lbs. | |
| Engine Mechanical | ||
| Compression | ENGINE COMPRESSION | |
| Oil Pressure (Hot) | 138-310 kPa @ 1500 RPM | |
| Overhaul | SPECIFICATIONS | |
| Torque | SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab.From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint."button | |
| Flywheel/Flex Plate Torque | 59 Ft. Lbs. (80 N.m) | |
| Fuel System | ||
| Fuel Filter Location | Under right rear door, mounted in worm clamp | |
| Fuel Filter R&I | REMOVAL & INSTALLATION (CONTINENTAL) | |
| Pressure Release Procedure | FUEL PRESSURE RELEASE | |
| Pressure Specification | FUEL PRESSURE SPECIFICATIONS | |
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE | |
| Ignition | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Spark Plugs | ||
| Type | Motorcraft AWSF-32E | |
| Gap | .052-.056 In. (1.32-1.42 mm) | |
| Torque | 11 Ft. Lbs. (15 N.m) | |
| Starting | ||
| Starter | STARTER MOTOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 95 Ft. Lbs.(129 N.m) CAUTION: Tighten wheel lug nuts in a star-pattern sequence. |
|