Pinpoint Test A: No Communication With The TPMS Module/Unable To Enter Self-Test
CAUTION:
The Flex Probe Kit must be used for all test connections. Use of standard multimeter probes may damage wiring terminals.
- A1 CHECK CIRCUITS 1002 (BK/VT) AND 1003 (GY/YE) FOR AN OPEN
- Disconnect: TPMS Module C3183.
- Key in ON position.
- Measure the voltage between TPMS module connector C3183-5, circuit 1002 (BK/VT) harness side and ground and between C3183-3, circuit 1003 (GY/YE) harness side and ground.
- Are the voltages greater than 10 volts?
- Yes : GO to A2.
- No : REPAIR circuit 1002 (BK/VT) or circuit 1003 (GY/YE). TEST the system for normal operation.
- A2 CHECK CIRCUIT 1205 (BK) FOR OPEN
- Measure the resistance between TPMS module harness connector C3183-6, circuit 1205 (BK) and ground.
- Is the resistance greater than 5 ohms?
- Yes : REPAIR circuit 1205 (BK). TEST the system for normal operation.
- No : CHECK the SCP communication circuits. REFER to MODULE CONFIGURATION .