Transmission Control Module (TCM): Installation

Verify that the manual lever position markings are aligned. Markings should indicate that the manual lever is in the OVERDRIVE position.

Fig 1: Locating Manual Lever Position Markings

Courtesy of FORD MOTOR CO.

Install the TCM.
- Tighten to 24 Nm (18 lb-ft).

Fig 2: Locating TCM Bolts

Courtesy of FORD MOTOR CO.

Install the manual control lever.

Fig 3: Locating Manual Control Lever

Courtesy of FORD MOTOR CO.

Install the manual control lever nut.
- Tighten to 12 Nm (106 lb-in).

Fig 4: Locating Manual Control Lever Nut

Courtesy of FORD MOTOR CO.

Connect the TCM electrical connector.

Fig 5: Locating TCM Electrical Connector

Courtesy of FORD MOTOR CO.

NOTE: Support the underside of the manual control lever when installing the selector lever cable or damage to the manual control lever or shaft may occur.

Connect the selector lever cable end.

Fig 6: Locating Selector Lever Cable End

Courtesy of FORD MOTOR CO.

Install the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 2.3L article or INTAKE AIR DISTRIBUTION AND FILTERING - 3.0L (4V) article.
Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
Carry out the TCM initial learning procedure. For additional information, refer to Transmission Control Module (TCM) Initial Learning .
Check for correct vehicle operation.