Front Controls Interface Module (FCIM) DTC Chart - MKZ Without Navigation, All Vehicles With Navigation
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
FRONT CONTROLS INTERFACE MODULE (FCIM) DTC CHART - MKZ WITHOUT NAVIGATION, ALL VEHICLES WITH NAVIGATION
| DTC | Description | Action |
|---|---|---|
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AE . |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test AJ . |
| U2013:63 | Switch Pack: Circuit/Component Protection Time-Out | GO to Pinpoint Test J . |
| U2014:41 | Control Module Hardware: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is still present, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) - MKZ . REPEAT the self-test. |
| U2014:42 | Control Module Hardware: General Memory Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:42 is still present, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) - MKZ . REPEAT the self-test. |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | REFER to MODULE CONFIGURATION . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AU . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AV . |