Normal Operation

The PSCM will use the motor inside the EPAS gear to calculate the relative and actual steering wheel angle, and then transmit this information to other modules over the HS-CAN.

1. E1: TEST DRIVE TO CHECK FOR RETURNING DTCS 
   NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

   Clear the PSCM DTCs.

   Cycle the ignition to OFF and then back to RUN.

   Test drive the vehicle in the following manner:

   • With the engine running/ready, stop the vehicle on an unsealed concrete or asphalt surface (in order to provide adequate friction for a thorough test).
   • With the vehicle in gear and the brakes applied, turn the steering wheel lock-to-lock.
   • Return the steering wheel to the center position and move the vehicle forward approximately 32 cm (1 ft).
   • With the vehicle in gear and the brakes applied, turn the steering wheel lock-to-lock.
   • Return the steering wheel to the center position and move the vehicle forward approximately 32 cm (1 ft).
   • With the vehicle in gear and the brakes applied, turn the steering wheel lock-to-lock.
   • The test drive is complete.

   Press Read Vehicle Information button to retrieve DTC s from the vehicle.

   NOTE: DTCs may be displayed from previous diagnostic actions.

   Is DTC C1B00:2F present? 

   Yes	No
   Go to E2.	The condition to set the DTC is not present at this time. DISCONNECT and INSPECT all 3 PSCM connectors for corrosion, bent terminals and/or pushed-out pins. REPAIR as necessary. If the connectors are okay. INSPECT the wire harness along the top of the EPAS gear for cuts, breaks and/or pinches. REPAIR as necessary. For all other PSCM DTCs, REFER to the DTC Index  .

2. E2: INSPECT THE INNER TIE RODS 

   With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .

   NOTE: When installing new bellows boots and clamps apply new lubricant as instructed to prevent water contamination or damage may result to the EPAS gear. For complete information refer to the Tie Rod - Inner Removal and Installation procedure in POWER STEERING .

   Inspect the inner tie rods for correct installation. Refer to POWER STEERING .

   Are the inner tie rods correctly installed? 

   Yes	No
   INSTALL a new EPAS gear. REFER to POWER STEERING .	INSTALL new inner tie rod(s).