Selector Lever

All Vehicles 

• 1.
  
  Apply the parking brake.

• 2.
  
  

Courtesy of FORD MOTOR COMPANY

• 3.
  
  On both sides.

Courtesy of FORD MOTOR COMPANY

MKX 

• 4.
  
  

Courtesy of FORD MOTOR COMPANY

• 5.
  
  

Courtesy of FORD MOTOR COMPANY

• 6.
  
  
  NOTE: Damage to the floor console rear trim panel may occur if cardboard is not used to remove the lower floor console side trim panel.
  NOTE: Position a piece of cardboard between the lower floor console side trim panel and the floor console. Remove the lower floor console side trim panel and cardboard simultaneously.

  On both sides.

Courtesy of FORD MOTOR COMPANY

• 7.
  
  On both sides.

Courtesy of FORD MOTOR COMPANY

• 8.
  
  On both sides.

Courtesy of FORD MOTOR COMPANY

• 9.
  
  

Courtesy of FORD MOTOR COMPANY

• 10.
  
  

Courtesy of FORD MOTOR COMPANY

• 11.
  
  
  NOTE: Ambient light is located at front of selector lever trim panel.

  If equipped.

  • 1.
    
    Detach the ambient wiring harness from the floor console.

  • 2.
    
    Rotate the ambient light counterclockwise and remove the ambient light from the floor console.

Courtesy of FORD MOTOR COMPANY

• 12.
  
  

Courtesy of FORD MOTOR COMPANY

All vehicles 

• 13.
  
  

Courtesy of FORD MOTOR COMPANY

• 14.
  
  

Courtesy of FORD MOTOR COMPANY

• 15.
  
  

Courtesy of FORD MOTOR COMPANY

• 16.
  
  
  • To Install, tighten to 5 Nm (44 lb-in).

Courtesy of FORD MOTOR COMPANY

• 17.
  
  To install, reverse the removal procedure.

• 18.
  
  Adjust the selector lever cable. For additional information, refer to Selector Lever Cable Adjustment - 6F50/6F55 .