Remote Function Actuator (RFA) Module: Installation
- Install RFA module.
- Connect the RFA module electrical connectors.
- Tighten to 3 Nm (27 lb-in).
- Install the RH side instrument panel hush panel.
- Connect the electrical connectors.
- Program the Intelligent Access (IA) keys (minimum of 2) into the new RFA module. For additional information, refer to Key Programming Using Diagnostic Equipment in Anti-Theft Passive Anti-Theft System (PATS) .
- Carry out the parameter reset between the RFA module and the Body Control Module (BCM). For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in Anti-Theft Passive Anti-Theft System (PATS) .
- Download the RFA module configuration information from the scan tool to the new RFA module by following the scan tool on screen instructions.
- Turn the ignition ON.
- Carry out the keyless entry keypad code reset. For additional information, refer to Keyless Entry Keypad Code Programming in Handles, Locks, Latches and Entry Systems .
- Carry out the RFA module self-test to confirm all DTCs have been cleared.