Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
When the driver presses the clutch pedal, the clutch pedal switch sends a signal to the PCM indicating the pedal has been pressed. The PCM sends a clutch pedal message to the GWM over the HS-CAN1. The GWM sends this message to the ABS module over the HS-CAN2. The ABS module monitors the clutch pedal message and vehicle speed. If the information indicates a concern with the clutch pedal, this DTC is set.
PPT BO ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | PPT AC ABS Module DTC Fault Trigger Conditions |
|---|---|---|
| C1A41:64 | Clutch Pedal Sensor: Signal Plausibility Failure | This DTC sets under a specific driving condition; if the vehicle is moving less than 3 km/h (2 mph) and after vehicle speed is greater than 80 km/h (49 mph) in the same ignition cycle, a clutch pedal signal change is expected to occur. If the clutch pedal signal change does not occur for 5 times, this DTC sets. |