| B103C:11 |
Left Headlamp Control: Circuit Short To Ground |
GO to Pinpoint Test J
. |
| B103C:15 |
Left Headlamp Control: Circuit Short To Battery or Open |
GO to Pinpoint Test J
. |
| B103C:49 |
Left Headlamp Control: Internal Electronic Failure |
DIAGNOSE all other DTCs first. If no other DTCs are present, INSTALL a new Headlamp Control Module (HCM). REFER to Headlamp Control Module (HCM)
. |
| B103C:98 |
Left Headlamp Control: Component or System Over Temperature |
INSTALL a new LH headlamp assembly. REFER to Headlamp Assembly
. |
| B103D:11 |
Right Headlamp Control: Circuit Short To Ground |
GO to Pinpoint Test K
. |
| B103D:15 |
Right Headlamp Control: Circuit Short To Battery or Open |
GO to Pinpoint Test K
. |
| B103D:49 |
Right Headlamp Control: Internal Electronic Failure |
DIAGNOSE all other DTCs first. If no other DTCs are present, INSTALL a new HCM. REFER to Headlamp Control Module (HCM)
. |
| B103D:98 |
Right Headlamp Control: Component or System Over Temperature |
INSTALL a new RH headlamp assembly. REFER to Headlamp Assembly
. |
| U0100:00 |
Lost Communication With ECM /PCM "A": No Sub Type Information |
GO to Pinpoint Test G
. |
| U0121:00 |
Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information |
GO to Pinpoint Test H
. |
| U0140:00 |
Lost Communication With Body Control Module: No Sub Type Information |
GO to Pinpoint Test I
. |
| U0401:00 |
Invalid Data Received from ECM /PCM A: No Sub Type Information |
DTC U0401:00 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to Multifunction Electronic Modules
. |
| U0415:00 |
Invalid Data Received from Anti-Lock Brake System (ABS) Control Module: No Sub Type Information |
DTC U0415:00 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to Multifunction Electronic Modules
. |
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
PROGRAM the HCM. REFER to Programmable Module Installation (PMI) in Module Configuration
. REPEAT the HCM self-test. If the DTC is returns, INSTALL a new HCM. REFER to Headlamp Control Module (HCM)
. |
| U3000:41 |
Control Module: General Checksum Failure |
INSTALL a new HCM. REFER to Headlamp Control Module (HCM)
. |