Pinpoint Test O : The Image Processing Module B (IPMB) Does Not Respond To The Diagnostic Scan Tool

WARNING: This page is about a different car, the 2017 Ford Police Interceptor Utility and 2017 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

O1 CHECK THE IPMB (IMAGE PROCESSING MODULE B) VOLTAGE SUPPLY CIRCUIT FOR AN OPEN

Ignition OFF.

Disconnect: IPMB C2515A .

Ignition ON.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C2515A-1	Courtesy of FORD MOTOR COMPANY	Ground

Is the voltage greater than 11 volts?

Yes

GO to O2

No	VERIFY the BJB fuse 34 (10A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the OEM WIRING DIAGRAMS to identify the possible causes of the circuit short.

O2 CHECK THE IPMB (IMAGE PROCESSING MODULE B) GROUND CIRCUIT FOR AN OPEN

Ignition OFF.

Measure:

Positive Lead	Measurement / Action	Negative Lead
C2515A-11	Courtesy of FORD MOTOR COMPANY	Ground

Is the resistance less than 3 ohms?

Yes

GO to O3

No	REPAIR the circuit.

O3 CHECK THE HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) CIRCUITS BETWEEN THE IPMB (IMAGE PROCESSING MODULE B) AND THE DLC (DATA LINK CONNECTOR) FOR AN OPEN

Disconnect IPMB C2512B .

Measure:

Positive Lead	Measurement / Action	Negative Lead
C2515B-7	Courtesy of FORD MOTOR COMPANY	C251-3
C2515B-6	Courtesy of FORD MOTOR COMPANY	C251-11

Are the resistances less than 3 ohms?

Yes

GO to O4

No	REPAIR the circuit in question.

O4 CHECK FOR CORRECT IPMB (IMAGE PROCESSING MODULE B) OPERATION

Ignition OFF.

Disconnect and inspect the IPMB connector and related in-line connectors.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the IPMB connector and related in-line connectors. Make sure they seat and latch correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new IPMB. REFER to: Image Processing Module B (IPMB) .

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.