Pinpoint Test C : DTCS P0562:00, P0563:00: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Wiring Diagram Four Wheel Drive Systems for schematic and connector information.
Normal Operation and Fault Conditions
If the TCCM observes an overpower or underpower voltage condition, a DTC is set and all TCCM outputs are turned off (IWE engaged).
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0562:00 | System Voltage Low: No Sub Type Information | This DTC sets when the TCCM detects battery voltage less than 9 volts for 5 seconds or more at the TCCM. |
| P0563:00 | System Voltage High: No Sub Type Information | This DTC sets when the TCCM detects battery voltage greater than 16 volts for 5 seconds or more at the TCCM. |
The pinpoint test is intended to diagnose following:
- Fuse
- Charging system
- Wiring, terminals or connectors
- TCCM