Pinpoint Test Q : The DSP (Audio Digital Signal Processing Module) Does Not Respond To The Diagnostic Scan Tool: Notes
WARNING: This page is about a different car, the 2018 Lincoln MKC. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Module Communications Network for schematic and connector information.
Refer to Audio System/Navigation - With THX for schematic and connector information.
Normal Operation and Fault Conditions
The DSP communicates on the HS-CAN3 and communicates with the diagnostic scan tool through the HS-CAN2. Diagnostic messages are sent/received through the HS-CAN2 circuits at the DLC, and are translated through the GWM to the HS-CAN3.
Possible Sources
- Fuse
- Wiring, terminals and connector
- DSP
Visual Inspection and Diagnostic Pre-checks
Verify BCM fuse 5 (20A) and 28 (20A) are OK.