September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Neutral Safety Switch
- Place gearshift lever in "N" position. Ensure gearshift linkage
is adjusted correctly. See
GEARSHIFT
LINKAGE
under ADJUSTMENTS. Loosen neutral safety switch
mounting bolts at transmission. Remove screw from alignment pin hole
at bottom of switch (if equipped).
- On 2.5L, place manual lever in Neutral. Line up neutral mark on
switch with manual lever.
- Tighten mounting bolts to specification. Refer to the
TORQUE
SPECIFICATIONS
table. Remove alignment pin. Install
alignment pin hole screw (if equipped), and check switch operation.
Vehicle should start only with gearshift in "P" or "N"
position.