Control Switch Test
Disconnect power seat main harness connector. Disconnect 2-pin connector at each seat motor. With control switch in specified position, check continuity between specified terminal of main harness connector and specified terminal of 2-pin seat motor connector. See CONTROL SWITCH CONTINUITY TEST table. See Fig 1 . Replace control switch if continuity is not as specified.
CONTROL SWITCH CONTINUITY TEST
| Switch Position | Terminals | |
|---|---|---|
| Slide Switch | ||
| Forward | "A" & "D"; "B" & "C" | |
| Backward | "A" & "C"; "B" & "D" | |
| Front Lift Switch | ||
| Up | "A" & "E"; "B" & "F" | |
| Down | "A" & "F"; "B" & "E" | |
| Rear Lift Switch | ||
| Up | "A" & "G"; "B" & "H" | |
| Down | "A" & "H"; "B" & "G" | |