Generator Warning Light
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the battery is fully charged.
- Charge if necessary.
- Verify that the drive belt deflection/tension is within the specification. (L3) (See DRIVE BELT INSPECTION [L3] .)
- Turn the ignition switch on and verify that the generator warning light illuminates.
- If not as specified, inspect generator warning light, wiring harnesses between the battery and the generator warning light.
- Verify that the generator warning light goes out after the engine is started.
- If not as specified, inspect if any of the following DTCs are displayed: P0112, P0113, P2502, P2503, P2504. (See ON-BOARD DIAGNOSTIC (ENGINE CONTROL SYSTEM (L3) .) (See SYMPTOM TROUBLE SHOOTING (ENGINE CONTROL SYSTEM (AJ) .)