LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2004 >> 3 s, 4D Hatchback, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System >> Basic System >> Airflow Mode Main Link Removal/Installation >> Notes
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Airflow Mode Main Link Removal/Installation: Notes

  1. Disconnect the negative battery cable.
  2. Detach the hood release lever from the lower panel. See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .
  3. Remove the front scuff plate. See FRONT SCUFF PLATE REMOVAL/INSTALLATION .
  4. Remove the front side trim. See FRONT SIDE TRIM REMOVAL/INSTALLATION .
  5. Remove the lower panel. See LOWER PANEL REMOVAL/INSTALLATION .
  6. Remove the shower duct (LH).
  7. Disconnect the airflow mode wire. See CLIMATE CONTROL UNIT REMOVAL .
  8. Remove the airflow mode rod (1).
  9. Remove the airflow mode main link.
    Fig 1: Removing Airflow Mode Main Link
    G00975551Courtesy of MAZDA MOTORS CORP.
  10. Install in the reverse order of removal.
  11. Adjust the airflow mode wire. See CLIMATE CONTROL UNIT WIRE ADJUSTMENT .
scientia non olet · About LEMON Manuals