LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2004 >> 3 s, 4D Hatchback, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System >> Control System >> Climate Control Unit Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Climate Control Unit Installation

  1. Pass each wire through the following routes and connect to A/C unit.
    Fig 1: Locating Airflow Mode Wire & Air Mix Wire (1 Of 2)
    G00975611Courtesy of MAZDA MOTORS CORP.
    Fig 2: Identifying Airflow Mode Wire & Air Mix Wire (2 Of 2)
    G00975612Courtesy of MAZDA MOTORS CORP.
  2. Connect the climate control unit connectors.
  3. Adjust the climate control unit wires. CLIMATE CONTROL UNIT WIRE ADJUSTMENT .
  4. Install the following parts:
    1. PJB and PJB bracket. See FUSES & CIRCUIT BREAKERS .
    2. Glove compartment. See GLOVE COMPARTMENT REMOVAL/INSTALLATION .
    3. Decoration panel. See DECORATION PANEL REMOVAL/INSTALLATION .
    4. Lower panel. See LOWER PANEL REMOVAL/INSTALLATION .
    5. Front side trim. See FRONT SIDE TRIM REMOVAL/INSTALLATION .
    6. Front scuff plate. See FRONT SCUFF PLATE REMOVAL/INSTALLATION .
    7. Detach the hood release lever from the lower panel. See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .
    8. Ashtray panel. See CONSOLE REMOVAL/INSTALLATION .
    9. Climate control unit
    10. Center panel module. See INTERIOR TRIM .
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals