September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Continuity Inspection: Notes
- Disconnect the negative battery cable.
- Remove the clutch switch. (See
CLUTCH PEDAL REMOVAL/INSTALLATION
.)
- Inspect for continuity between the clutch switch terminals B and D using an ohmmeter.
- If the clutch switch is okay, but the PID value is out of specification, perform the "Circuit Open/Short Inspection".
- If not as specified, replace the clutch switch. (See
CLUTCH PEDAL REMOVAL/INSTALLATION
.)
Courtesy of MAZDA MOTORS CORP.