Generator warning light
- Verify that the battery is fully charged.
- Verify that the drive belt deflection/tension is correct. (See
DRIVE BELT INSPECTION
.)
- With the ignition switch at ON, verify that the generator warning light illuminates.
- If it does not illuminate, inspect the generator warning light and the wiring harness.
- If the generator warning light and the wiring harness are normal, inspect the PCM.
- Verify that the generator warning light goes off after the engine is started.
- If it does not goes out, check if any one of the following DTCs in the on-board diagnostic system are displayed: P0112, P0113, P2502, P2503, P2504. (See
DTC TABLE
.)