LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2005 >> 3 i, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System] >> DTC P0607 >> Diagnostic procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Diagnostic procedure

DTC P0607 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Technical Service Bulletin(s) repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to available repair information.
  • If vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY TROUBLESHOOTING OF P0607 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear DTC from PCM memory using WDS or equivalent.
  • Start the engine.
  • Is same DTC present?
 Yes Replace PCM, go to the next step. (See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE  Yes Go to applicable DTC inspection. (See DTC TABLE )
No Troubleshooting completed.
scientia non olet · About LEMON Manuals