DTC P2108: Notes

DTC P2108 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P2108	Throttle actuator control module performance problem
DETECTION CONDITION	If the PCM detects either of the following conditions, the PCM determines that throttle actuator control system has a malfunction. TP sensor power supply voltage below 4.4 V TP sensor No. output voltage below 0.20 V or above 4.85 V (DTC P0122 or P0123) TP sensor No. output voltage below 0.20 V or above 4.85 V (DTC P0222 or P0223) PCM internal circuit for TP sensor No. input circuit malfunction. Diagnostic support note This is a continuous monitor (CCM). MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle. FREEZE FRAME DATA is available. DTCs are stored in PCM memory.
POSSIBLE CAUSE	TP sensor No. malfunction TP sensor No. malfunction Connector or terminal malfunction Open circuit between throttle body terminal A and PCM terminal 3M Short to ground between throttle body terminal A and PCM terminal 3M Open circuit between throttle body terminal B and PCM terminal 3P Open circuit between throttle body terminal D and PCM terminal 3Q Short to the constant voltage supply between throttle body terminal A and PCM terminal 3M Short to the constant voltage supply between throttle body terminal C and PCM terminal 3J PCM malfunction

DTC P2108

Throttle actuator control module performance problem

DETECTION CONDITION

If the PCM detects either of the following conditions, the PCM determines that throttle actuator control system has a malfunction.
- TP sensor power supply voltage below 4.4 V
- TP sensor No. output voltage below 0.20 V or above 4.85 V (DTC P0122 or P0123)
- TP sensor No. output voltage below 0.20 V or above 4.85 V (DTC P0222 or P0223)
- PCM internal circuit for TP sensor No. input circuit malfunction.

Diagnostic support note

This is a continuous monitor (CCM).
MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
FREEZE FRAME DATA is available.
DTCs are stored in PCM memory.

POSSIBLE CAUSE

TP sensor No. malfunction
TP sensor No. malfunction
Connector or terminal malfunction
Open circuit between throttle body terminal A and PCM terminal 3M
Short to ground between throttle body terminal A and PCM terminal 3M
Open circuit between throttle body terminal B and PCM terminal 3P
Open circuit between throttle body terminal D and PCM terminal 3Q
Short to the constant voltage supply between throttle body terminal A and PCM terminal 3M
Short to the constant voltage supply between throttle body terminal C and PCM terminal 3J
PCM malfunction