Steering Lock Unit Id Code Registration [With Advanced Keyless System]
CAUTION:
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed.
- WDS or equivalent
- Personal computer
- Device that can send/receive radio waves
NOTE:
- The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock unit. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
- For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the card key programming.
- Bring the programmed card key into the vehicle.
- Fully lower the driver-side door glass.
- Connect the WDS or equivalent to the DLC-2.
- Pull out the WDS or equivalent cable from the door glass opening and set the WDS or equivalent outside the vehicle.
- Select "BODY/SECURITY/PATS (immobilizer)" from the WDS or equivalent screen menu.
- Perform the security access according to the directions on the WDS or equivalent screen. (See SECURITY ACCESS PROCEDURE .)
- The security access begins and the WDS or equivalent displays "OUT-CODE".NOTE:
- When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times will change the "OUT-CODE".
- Input the "IN-CODE" that corresponds to the "OUT-CODE" displayed on the WDS or equivalent screen.
- Select "STEERING LOCK UNIT PROGRAMMING" and perform procedures according to the directions on the WDS or equivalent screen.