LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 3 Mazdaspeed, 2.3 M >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control >> DSC System Inspection >> ABS Control Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ABS Control Inspection

  1. Perform "PREPARATION ".
  2. Connect the M-MDS to the DLC-2.
  3. Set up an active command mode inspection according to the combination of commands below. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
    Fig 1: Identifying DLC-2 Connector Location
    G04955736Courtesy of MAZDA MOTORS CORP.

    Brake pressure retention 

    BRAKE PRESSURE RETENTION

    Command name Inspected wheels
    LF RF LR RR
    LF_TC_PRV OFF
    RF_TC_PRV
    LF_TC_SWV
    RF_TC_SWV
    LF-NLET ON OFF OFF OFF
    LF_OUTLET OFF
    LR_INLET ON
    LR_OUTLET OFF
    RF_NLET ON
    RF_OUTLET OFF
    RR_INLET ON
    RR_OUTLET OFF
    PMP_MOTOR

    Brake pressure reduction 

    BRAKE PRESSURE RETENTION

    Command name Inspected wheels
    LF RF LR RR
    LF_TC_PRV OFF
    RF_TC_PRV
    LF_TC_SWV
    RF_TC_SWV
    LF_NLET ON OFF OFF OFF
    LR_OUTLET
    LR_NLET OFF ON
    LR_OUTLET
    RF_INLET ON OFF
    RF_OUTLET
    RR_INLET OFF ON
    RR_OUTLET
    PMP_MOTOR ON
    CAUTION:
    • When operating the solenoid valve and pump motor using the active command mode, make sure to keep the operation time within 2 s to prevent damaging the DSC HU/CM.
    NOTE:
    • When working with two people, one should press on the brake pedal, the other should attempt to rotate the wheel being inspected.
  4. Send the command while depressing on the brake pedal and attempting to rotate the wheel being inspected.
  5. When brake pressure is maintained and a DSC HU/CM operation click sound is heard, confirm that the wheel does not rotate. When brake pressure is being reduced and a DSC HU/CM operation click sound is heard, confirm that the wheel rotates.
    • Performing the inspection above determines the following:
      • The DSC HU/CM brake lines are normal.
      • The DSC HU/CM hydraulic system has no significant malfunction (including DSC HU/CM).
      • The DSC HU/CM internal electrical parts (solenoid, motor and other parts) are normal.
      • The DSC unit and DSC HU/CM output system wiring harnesses (solenoid valve, relay system) are normal.
    • However, the following items cannot be verified.
      • Intermittent malfunction of the above items
      • Malfunction of DSC HU/CM input system wiring harnesses and parts
      • Extremely small leakage in the DSC HU/CM internal hydraulic system
scientia non olet · About LEMON Manuals