ECT Sensor Resistance Inspection
- Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS .)
- Remove the ECT sensor (located above the starter).
- Place the ECT sensor in water with a thermometer, and heat the water gradually.
- Measure the resistance between the ECT sensor terminals A and B using a tester.
- If not as specified, replace the ECT sensor.
- If the ECT sensor is normal, but PID value is out of specification, perform the "CIRCUIT OPEN/SHORT INSPECTION ".
WATER TEMPERATURE AND RESISTANCE SPECIFICATIONWater temperature (°C {°F}) Resistance (kilohm) 20 {68} 35.48-39.20 80 {176} 3.65-4.02