Abs/TCS HU/Cm Configuration

Connect the M-MDS to the DLC-2.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select the "Module Programming".
- When using the PDS (Pocket PC)
  1. Select "Programming".
  2. Select "Module Programming".
Then, select the "PROGRAMMABLE MODULE INSTALLATION" and "ABS" from the screen menu.
Perform the configuration according to the directions on the screen.
Retrieve the DTCs using the M-MDS, then verify if DTCs are present.
- If a DTC is present, perform the applicable DTC inspection. SeeON-BOARD DIAGNOSTIC (ABS/TCS) -- MAZDA6 .
  
  Fig 1: Locating DLC-2 Connector
  Courtesy of MAZDA MOTORS CORP.