Cruise Control System Pinpoint Test 8: Cruise Control Indicator Lamp Is Always On

CRUISE CONTROL INDICATOR LAMP IS ALWAYS ON - PINPOINT TEST REFERENCE

PINPOINT TEST 8		CRUISE CONTROL INDICATOR LAMP IS ALWAYS ON
STEP	INSPECTION		ACTION
1	CHECK CRUISE CONTROL SERVO Key in OFF position. Disconnect: cruise control servo 0120-101. Key in ON position. Check the cruise control indicator lamp. Does the cruise control indicator lamp remain on?	Yes	Go to next step.
1		No	Install a new cruise control servo. See CRUISE CONTROL SERVO REMOVAL / INSTALLATION . Test the system for normal operation.
2	CHECK CIRCUIT V/W FOR SHORT TO GROUND Key in OFF position. Disconnect: Smart junction box (SJB) J-2280a. Measure the resistance between the speed control servo 0120-101 pin 1 circuit V/W, harness side and ground. Is the resistance greater than 10, 000 ohms?	Yes	Go to next step.
2		No	Repair the V/W circuit. Test the system for normal operation.
3	CHECK FOR CORRECT SJB OPERATION Disconnect all the SJB connectors. Check for: corrosion. damaged pins. pushed-out pins. Connect the SJB connectors and make sure they seat correctly. Operate the system and verify the concern is still present. Is the concern still present?	Yes	Install a new SJB. See SMART JUNCTION BOX (SJB) . Perform the self-test diagnostics.
3		No	The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.