DTC P0500: Notes
DTC P0500 DETECTION & CONDITION POSSIBLE CAUSES
| DTC P0500 |
VSS circuit problem |
| DETECTION CONDITION |
- The PCM monitors the input signal from the vehicle speed sensor when the following conditions are met. If the input signal is less than 3.7 km/h {2.3 mph}
, the PCM determines that there is a VSS circuit malfunction.
MONITORING CONDITION
- Shift lever position: gear is not in neutral position
- Engine speed: more than 2,500 rpm
- LOAD: more than 40.0%
Diagnostic support note
- This is a continuous monitor (CCM).
- The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- ABS HU/CM malfunction (with ABS HU/CM)
- DSC HU/CM malfunction (with DSC HU/CM)
- PCM malfunction
|