DTC P2070: Notes
DTC P2070 DETECTION & CONDITION POSSIBLE CAUSES
| DTC P2070 |
SSV stuck open |
| DETECTION CONDITION |
- The PCM monitors the input signal from the SSV switch when the PCM turns the SSV solenoid valve off. If the input signal is on, the PCM determines that the SSV is stuck open.
Diagnostic support note
- This is a continuous monitor (CCM).
- The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- SSV stuck open
- SSV control malfunction
- SSV actuator malfunction
- SSV solenoid valve malfunction
- SSV switch malfunction
- PCM malfunction
|