DTC P2404: Notes
DTC P2404 DETECTION & CONDITION POSSIBLE CAUSES
| DTC P2404 |
EVAP system leak detection pump sense circuit range/performance problem |
| DETECTION CONDITION |
- The PCM monitors the pump load current (EVAP line pressure) when the evaporative leak monitor is operating. If the time in which the pump load current reaches the reference current value is not within the specification after the PCM obtains the reference current value, the PCM determines that there is an EVAP system leak detection pump sense circuit range/performance problem.
Diagnostic support note
- This is an intermittent monitor (EVAP system).
- The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- EVAP hose bending
- Air filter clogging
- PCM malfunction
|