Section 657 (Security System And Locks System)
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Security And Locks Location Index
- Front Outer Handle Removal/Installation
- Front Inner Handle Removal/Installation
- Hood Latch And Release Lever Removal/Installation
- Hood Striker Removal/Installation
- Hood Latch Switch Inspection
- Front Door Key Cylinder Removal/Installation
- Front Door Latch And Lock Actuator Removal/Installation
- Door Lock Switch Removal/Installation
- Door Lock Switch Inspection
- Front Door Lock Actuator Inspection
- Front Door Lock Striker Removal/Installation
- Rear Door Lower Latch Removal/Installation
- Rear Door Upper Latch Switch Inspection
- Rear Door Upper Latch Removal/Installation
- Rear Door Lock Striker Removal/Installation
- Rear Door Release Handle Removal/Installation
- Fuel-Filler Lid Opener Removal/Installation
- Trunk Lid Latch And Opener Removal/Installation
- Trunk Lid Opener Inspection
- Trunk Lid Opener Switch Removal/Installation
- Trunk Lid Opener Switch Inspection
- Trunk Lid Striker Removal/Installation
- Trunk Key Cylinder Removal/Installation
- Trunk Key Cylinder Switch Inspection
- Trunk Lid Open Cancel Switch Removal/Installation
- Trunk Lid Open Cancel Switch Inspection
- Keyless Control Module Removal/Installation
- Keyless Control Module Inspection[With Advanced Keyless System]
- Keyless Control Module Inspection[Without Advanced Keyless System]
- Keyless Control Module Configuration
- Transmitter Battery Replacement[With Keyless Entry System]
- Transmitter Id Code Registration[With Keyless Entry System]
- Door Lock Control Module Removal/Installation[With Advanced Keyless System]
- Door Lock Control Module Inspection[With Advanced Keyless System]
- Card Key Id Code Registration[With Advanced Keyless System]
- Clearing Card Key[With Advanced Keyless System]
- Steering Lock Unit Id Code Registration[With Advanced Keyless System]
- Customized Function Setting Procedure[With Advanced Keyless System]
- Keyless Receiver Removal/Installation[With Advanced Keyless System]
- Keyless Receiver Inspection[With Advanced Keyless System]
- Keyless Antenna Removal/Installation
- Keyless Beeper Removal/Installation[With Advanced Keyless System]
- Request Switch Removal/Installation[With Advanced Keyless System]
- Request Switch Inspection[With Advanced Keyless System]
- Card Key Battery Replacement[With Advanced Keyless System]
- Coil Removal/Installation
- Security Access Procedure
- Immobilizer System Component Replacement/Key Addition And Clearing[With Advanced Keyless System]
- Foreword
- M-MDS Connecting Procedure
- No.1 Additional Key Programming Procedure (Using Two Valid Keys)
- No. 2 Key Additional Programming Procedure (Using the M-MDS)
- No.3 PCM Replacement Procedure
- No. 4 Key Additional Programming Procedure Changing
- No.5 Resetting Procedure for the Immobilizer System when Replacing the related parts
- Immobilizer System Component Replacement/Key Addition And Clearing[With Keyless Entry System]
- Foreword
- No.1 Additional Key Registration Procedure (Using Two Valid Keys)
- No.2 Additional Key Registration Procedure (Using the M-MDS)
- No.3 Key Replacement Procedure (Clearing Previously Registered Key ID Numbers, Key Re-registration)
- No.4 Changing the Method for Registering Additional Keys
- No.5 Resetting Procedure for the Immobilizer System when Replacing the PCM or Keyless Control Module
- No.6 Security Access Procedure