Normal Operation

Under normal operation, the driver window control switch is supplied voltage through circuit (GY/Y). Ground for the switch is provided through circuit (B/L).

This pinpoint test is intended to diagnose the following:

Wiring, terminals or connectors
Driver window control switch

POWER WINDOWS REFERENCE - PINPOINT TEST 1

PINPOINT TEST 1		ALL POWER WINDOWS ARE INOPERATIVE
STEP	INSPECTION		ACTION
1	VERIFY THE PASSENGER WINDOW OPERATES FROM THE PASSENGER WINDOW CONTROL SWITCH Key OFF. Attempt to operate the passenger power window from the passenger window control switch. Does the passenger power window operate?	Yes	See PINPOINT TEST 2: SINGLE POWER WINDOW IS INOPERATIVE - DRIVER POWER WINDOW .
1		No	Go to next step.
2	CHECK THE VOLTAGE TO THE DRIVER WINDOW CONTROL SWITCH Key in OFF position. Disconnect: Driver Window Control Switch connector 0912-201. Key in ON position. Measure the voltage between driver window control switch 0912-201 pin 7, circuit (GY/Y), harness side and ground. Is the voltage greater than 10 volts?	Yes	Go to next step.
2		No	Go to PINPOINT TEST 4: THE DELAYED ACCESSORY RELAY IS INOPERATIVE/DOES NOT OPERATE CORRECTLY .
3	CHECK THE GROUND TO THE DRIVER WINDOW CONTROL SWITCH Key in OFF position. Measure the resistance between driver window control switch 0912-201 pin 2, circuit (B/L), harness side and ground. Is the resistance less than 5 ohms?	Yes	INSTALL a new driver window control switch. TEST the system for normal operation.
3		No	REPAIR circuit (B/L) for an open. TEST the system for normal operation.