September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Manifold Absolute Pressure (Map) Sensor Removal/Installation - 2.5L
Courtesy of MAZDA MOTORS CORP.
- With the vehicle in NEUTRAL, position it on a hoist. See LIFTING
.
- Disconnect the MAP electrical connector.
- Using a tool like KD Tool #58181 or Lisle T25 Torx Bit, remove the screw and the MAP sensor.
- To install, tighten to 3 N.m (0.3 kgf.m, 27 in.lbf).
- To install, reverse the removal procedure.
NOTE:
- Lubricate the MAP sensor O-ring seal with clean engine oil.