Clutch Pedal Position (CPP) Switch Inspection
- Verify that the CPP switch is installed properly.
- Disconnect the negative battery cable.
- Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
- Inspect for continuity between the CPP switch terminals using an ohmmeter.
- If not as specified, replace the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
Specification
CONTINUITY SPECIFICATIONMeasured condition Clutch pedal position Continuity Rod pushed Clutch pedal released Continuity detected Except above Clutch pedal depressed No continuity