LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2011 >> CX-9 Touring, 3.7 A, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System [MZI-3.7] >> Camshaft Position (CMP) Sensor Inspection >> Resistance Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Resistance Inspection

  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7] .)
  2. Disconnect the CMP sensor connector.
  3. Measure the resistance between the CMP sensor terminals A and B.
    • If not within the specification, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION .)
    • If the monitor item status/specification (reference) is not within the specification, even though the resistance is within the specification, perform the "Circuit Open/Short Inspection".

    CMP sensor resistance 

    1,146-1,420 ohms 

scientia non olet · About LEMON Manuals