Diagnostic Procedure

Step	Inspection		Action
1	VERIFY NUMBER OF PROGRAMMED ADVANCED KEYS Perform the PID/data monitor inspection using the M-MDS. (See PID/DATA MONITOR INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) NUMCARD (See PID/DATA MONITOR TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Is there a programmed advanced key?	Yes	Go to the next step.
1		No	Program a new advanced key, then go to the next step. (See ADVANCED KEY ID CODE REGISTRATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
2	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from keyless control module memory using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Is the same DTC present?	Yes	Replace the keyless control module, then go to the next step. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
3		No	DTC troubleshooting completed.