Diagnostic Procedure

Step	Inspection		Action
1	PERFORM ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM DTC INSPECTION Clear the DTC from keyless control module memory using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Are the following DTCs present? B10E7:12 B10E7:17	Yes	Go to the applicable DTC inspection. (See DTC B10E7:12 [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) (See DTC B10E7:17 [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
1		No	Go to the next step.
2	PERFORM PCM DTC INSPECTION Perform the PCM DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.5] .) (See ON-BOARD DIAGNOSTIC TEST [MZI 3.7 V6] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZR 2.5] .) (See DTC TABLE [MZI 3.7 V6] .)
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from keyless control module memory using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Switch the ignition to off, then open the door to lock the steering. Perform the advanced keyless entry and push button start system DTC inspection using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) Is the same DTC present?	Yes	Replace the keyless control module, then go to the next step. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
3		No	Go to the next step.
4	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
4		No	DTC troubleshooting completed.