DTC Inspection [Immobilizer System (Advanced Keyless Entry And Push Button Start System)]: M-MDS

Connect the M-MDS to the DLC-2.

Fig 1: Identifying DLC-2 Location
After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select "Self test"
  2. Select "Modules"
  3. Select "RKE"
Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. When several DTCs are detected, repair the malfunctioning location based on the DTC displayed by the security light.
  (See DTC TABLE [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] .)
NOTE:
- Because of the possibility that one malfunction cause could result in several DTCs being detected, erase the DTCs after the repair is completed, and then check for DTCs again.
After completion of repairs, clear all DTCs stored in the keyless control module.
(See CLEARING DTC [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] .)