No.1 Additional Key Programming Procedure (Using Two Valid Keys): Procedure

Fig 1: No.1 Additional Key Chart

Step	Procedure	Action after procedure
1	LAUNCH PROGRAMMING MODE  Switch the ignition to ON using key 1. After verifying that the security light illuminates for approx. 3 s and turns off, switch the ignition off within approx. 4 s using key 1. Remove key 1. Switch the ignition to ON using key 2. After verifying that the security light illuminates for approx. 3 s and turns off, switch the ignition off within approx. 4 s using key 2. Remove key 2.	Go to the next step.
2	PERFORM ADDITIONAL KEY PROGRAMMING  Switch the ignition to ON using key 3. Verify that the security light illuminates for approx. 3 s  , and then turns off. Remove key 3. Are there other keys to be programmed?	Yes	Go back to Step 1.
		No	Go to the next step.
3	VERIFY THAT ANY KEY IS PROGRAMMED  Verify that the engine can start and run for 5 s or more using all the programmed keys. NOTE: When verifying that the engine starts, wait at least 5 s or more  before starting the engine using the next key.	Procedure is completed