No.3 Additional Key Programming Procedure Changing: Procedure

Step	Procedure	Action after procedure
1	CHANGE CUSTOMER SPARE KEY PROGRAMMING PROCEDURE Connect the M-MDS (IDS) to the DLC-2. (See M-MDS CONNECTING PROCEDURE .) Switch the ignition ON using a key (the key can be either the valid key or an unprogrammed key). NOTE: If an unprogrammed key is used, the security light starts flashing and DTC 15 is displayed after approx. 1 min. However, this does not indicate an improper procedure. Continue to perform the procedure as indicated. After the vehicle is identified, select the following items from the initial screen of the M-MDS. When using the IDS (laptop PC): Select the "Body" Select the "Security" Select the "PATS Functions" Select either of the following from the M-MDS menu to change the additional key programming procedure. When "Customer Spare Key Programming Enable" is selected: The additional key programming procedure using valid keys is enabled. When "Customer Spare Key Programming Disable" is selected: The additional key programming procedure using valid keys is disabled. Perform the security access according to the directions on the M-MDS screen. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)". Switch the ignition to off.	Procedure is completed