If active command mode function of the M-MDS is used

1. Start the engine.
2. Disconnect the vacuum hose between the purge solenoid valve and the charcoal canister.
3. Put the finger to the purge solenoid valve and verify that there is no vacuum applied when the engine is cold.
   • If there is a vacuum, inspect the following:
     • Wiring harness and connectors (Purge solenoid valve terminal B-PCM terminal 2H)
     • Purge solenoid vale (stuck open) (See PURGE SOLENOID VALVE INSPECTION .)
4. Connect the M-MDS to the DLC-2 and verify that the DTC P0443:00 is shown.
   • If the P0443:00 are displayed, perform the DTC inspection. (See DTC P0443:00 .)
5. Select the PCM PID EVAPCP.
6. Increase the duty value of the purge solenoid valve to 50 %  and inspect if the operation sound of the valve is heard.
   • If the operation sound is heard, inspect for the loose or damaged vacuum hose. (Intake manifold-Purge solenoid valve-Charcoal canister)
   • If the operation sound is not heard, perform the purge solenoid valve inspection.

     (See PURGE SOLENOID VALVE INSPECTION .)

7. Warm up the engine to normal operating temperature.
8. Monitor the EVAPCP PID using the M-MDS, and drive the vehicle approx. 2, 000 rpm for 30 s or more  .
   • If the EVAPCP PID is 0 %  , inspect the PCM PIDs MAF, APP1, APP2, TP REL and LOAD.

f active command mode function of the M-MDS is not used: 

1. Start the engine.
2. Disconnect the vacuum hose between the purge solenoid valve and the charcoal canister.
3. Put the finger to the purge solenoid valve and verify that there is no vacuum applied when the engine is cold.
   • If there is a vacuum, inspect the following:
     • Wiring harness and connectors (Purge solenoid valve-PCM terminal 2H)
     • Purge solenoid vale (stuck open) (See PURGE SOLENOID VALVE INSPECTION .)
4. Connect the M-MDS to the DLC-2 and verify that the DTC P0443:00 is shown.
   • If the P0443:00 are displayed, perform the DTC inspection. (See DTC P0443:00 .)
5. Access the PCM PIDs EVAPCP and ECT.
6. Verify that the ECT PID is more than 78 °C {172 °F}  .
   • If the ECT PID reading indicates less than 78 °C {172 °F}  , perform the CHT sensor inspection. (See CYLINDER HEAD TEMPERATURE (CHT) SENSOR INSPECTION .)
7. Set the vehicle on the dynamometer or chassis roller.
   WARNING:

   • When the dynamometer or chassis roller is operating, there is a possibility that the operator may come into contact with or be caught up in the rotating parts, leading to serious injuries or death. When performing work while the dynamometer or chassis roller is operating, be careful not to come into contact with or caught up in any of the rotating parts.
8. Drive the vehicle approx. 2, 000 rpm  for 30 s or more  .
   • If there is no vacuum, inspect the following:
     • Wiring harness and connector (Main relay-Purge solenoid valve-PCM terminal 2H)
     • Purge solenoid valve (See PURGE SOLENOID VALVE INSPECTION .)
     • MAF, APP1, APP2, TP REL and LOAD PIDs
   • If there is vacuum, inspect the following:
     • Vacuum hose (Purge solenoid valve-Charcoal canister)