Purge Control System Inspection
- Start the engine.
- Disconnect the vacuum hose between the purge solenoid valve and the charcoal canister.
- Put a finger to the purge solenoid valve and verify that there is no vacuum applied when the engine is cold.
- If there is a vacuum, inspect the following:
- Warm up the engine to the normal operating temperature.
- Stop the engine.
- Connect the M-MDS to the DLC-2 and verify that the DTC P0443:00 is shown. Perform the DTC inspection. (See
DTC P0443:00 [MZR 1.5]
).
- Switch the ignition to ON.
- Access the ECT1 PID. (See
ON-BOARD DIAGNOSTIC TEST [MZR 1.5]
).
- Verify that the engine coolant temperature is more than 60 °C {140 CF}
.
- Put a finger to the purge solenoid valve and verify that there is vacuum applied with engine at idle and warmed up.
- If there is no vacuum, inspect the following:
- Wiring harness and connectors (Main relay-Purge solenoid valve terminal B-PCM terminal 2S)
- Purge solenoid valve (stuck close) (See
PURGE SOLENOID VALVE INSPECTION
).
- MAF, APP1, APP2, TP REL and LOAD PIDs (See
PCM INSPECTION
).
- If there is a vacuum, inspect the following:
- Wiring harness and connectors (Purge solenoid valve terminal B-PCM terminal 2S)
- Vacuum hose (Purge solenoid valve-Charcoal canister)