LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2013 >> 2 Touring, 1.5L Eng VIN Z, Automatic Trans >> Repair and Diagnosis >> Steering >> Power Steering >> Electric Power Steering System >> EPS Control Module Inspection >> Notes
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

EPS Control Module Inspection: Notes

  1. Remove the side wall. (See SIDE WALL REMOVAL/INSTALLATION ).
  2. Remove the front console component. (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION ).
  3. Remove the front scuff plate (LH) and front side trim (LH). (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .) (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
  4. Disconnect the hood release lever from the lower panel. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION ).
  5. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION ).
  6. Remove the heat duct (LH). (See HEAT DUCT COMPONENT REMOVAL/INSTALLATION ).
  7. Attach the tester lead to the underside of the EPS CM connector and inspect the voltage according to the terminal voltage table (reference).
scientia non olet · About LEMON Manuals