LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2013 >> 2 Touring, 1.5L Eng VIN Z, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System [MZR 1.5] >> Crankshaft Position (CKP) Sensor Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position (CKP) Sensor Removal/Installation

CAUTION:
  • When replacing the CKP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control.
  1. Disconnect the negative battery cable.
  2. Remove the splash shield.
  3. Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION ).
  4. Disconnect the CKP sensor connector.
    Fig 1: Splash Shield (RH) And Mounting Bolts With Torque Specification
    G09130342
  5. Remove the CKP sensor.
  6. Install in the reverse order of removal.
    Fig 2: CKP Sensor And Mounting Bolts With Torque Specification
    G09130343
scientia non olet · About LEMON Manuals